How I Repaired A Dualit Milk Frother Model DMF2

This post was written using the WP Gutenberg editor version 2.7.0.

Introduction

My wife pressed the start button on the Dualit Milk Frother (Model DMF2) one day in the summer of 2017 and it no longer worked. This persisted so we had to heat the milk in the microwave oven for a week or two until we got a new frother.

Of course, me being me, I dismantled the faulty Dualit Milk Frother to see if there was an obvious problem. There wasn’t anything burnt out or blackened. Just a lot of wiring in a very confined space. It was constructed with a flat straight circuit board fitted into a curved space. No-one had used flexible circuit boards here.

The long term solution was to replace the whole Dualit Milk Frother. Since they are still on the market that’s what I chose to do. The faulty one had been a replacement for our Nespresso Aeroccino Milk Frother already mentioned in this blog. We now had to replace the replacement.

Continue reading “How I Repaired A Dualit Milk Frother Model DMF2”

Dyson Slim DC18 Cleaner Head Maintenance

Introduction

This article advises how to perform Dyson Slim DC18 Cleaner Head Maintenance. This can involve removing the Brushbars to remove items that have got wrapped around them and removing the Soleplate for access  so dirt can be cleaned out. In extreme cases the Motor Housing can be opened so that dirt can be sucked out of it too.

Continue reading “Dyson Slim DC18 Cleaner Head Maintenance”

Dyson Slim DC18 Filter Cleaning

Introduction

This article describes the Dyson Slim DC18 Filter Cleaning process for the Pre-filter and the HEPA (Highly Efficient Particle Arrester) Post-filter.

Many devices in this world which pump air have air filters installed to prevent dirt getting into mechanical parts and clogging them up to the point where they perform badly or fail.  The air filters clog instead and have to be replaced or cleaned at regular intervals. The Dyson Slim DC18 is no different. It has two air filters:

  1. A Pre-filter (before the motor) which requires periodic cleaning by the user every 3 to 6 months under normal usage. This sits on top of the Cyclone within the Cyclone Assembly and is placed between the Cyclone and the motor. It prevents dirt entering the motor bearings or clogging up the space around the rotor.
  2. A HEPA Post-filter (after the motor) which doesn’t require user attention. This sits on top of the motor and filters the air leaving the DC18. It captures allergenic particles which have been drawn into the cleaner and prevents them being reintroduced to the local atmosphere.

The method of cleaning the Pre-filter, on all the Dyson machines that I have seen, requires the air filter to be washed with water under a running tap. This is an easy way to clean a filter which is designed to be flexible so that it can be squeezed to remove the water it absorbs in the washing process. The dirt is washed away and doesn’t get into the air which would cause a breathing hazard for the user. Continue reading “Dyson Slim DC18 Filter Cleaning”