This post was written using the WP Gutenberg editor version 2.7.0.
My wife pressed the start button on the Dualit Milk Frother (Model DMF2) one day in the summer of 2017 and it no longer worked. This persisted so we had to heat the milk in the microwave oven for a week or two until we got a new frother.
Of course, me being me, I dismantled the faulty Dualit Milk Frother to see if there was an obvious problem. There wasn’t anything burnt out or blackened. Just a lot of wiring in a very confined space. It was constructed with a flat straight circuit board fitted into a curved space. No-one had used flexible circuit boards here.
The long term solution was to replace the whole Dualit Milk Frother. Since they are still on the market that’s what I chose to do. The faulty one had been a replacement for our Nespresso Aeroccino Milk Frother already mentioned in this blog. We now had to replace the replacement.
Continue reading “How I Repaired A Dualit Milk Frother Model DMF2”
This post refers specifically to downpipes with a square cross section. It shows how to modify a rainwater downpipe spout (shoe) to stop a dripping noise when the drip starts within the outlet shoe. For drips that drop off the guttering outlet and fall all the way down to the bottom of a straight downpipe and hit the shoe you may get immediate relief from the noise by removing the shoe and letting the drip fall on the ground, roof or whatever is below the downpipe. In the long term this may cause excessive splashing under heavy rain which could cause damage to foundations or brickwork mortar, because the water is not directed away from the building. The drip needs to be guided to the side of the downpipe so it will run down the pipe and only tend to drip at the bottom where it can be dealt with by the method described here. Any method devised must not prevent leaves and dirt from being washed all the way down the pipe or a blockage will ensue.
Continue reading “Dripping noise from a rainwater spout”