I’ve had a Nespresso Pixie since June 2012 and at the same time I acquired a Nespresso Aeroccino milk frother (Aeroccino 3 to be precise). These devices are very nice to have and work well even after 2½ years continual use. The coffee is very nice too.
However there is a slight problem with the Nespresso Aeroccino milk frother but it is not insurmountable. It’s very easy to burn milk on the bottom where the most intense heat is applied. You can see it burnt on in this picture where the whisk has been removed.
This article advises how to keep a Nespresso Aeroccino milk frother clean. There are pictures portraying the burnt milk problem and advice is given on how to avoid it.
You may be surprised to learn that the shower head that came with my Mira Sport Thermostatic Shower is made from 22 separate parts. If you count them in the featured image above you will see 21 but take note that the main body of the shower head, on the right, is made from two inseparable parts of plastic.
I can also tell you that the main body of the shower head retains water after use. Some drops can be removed by shaking it in various ways but some always remains inside. If the shower isn’t used regularly this water will become stagnant and may hold dangerous bacteria. I would recommend turning the shower on at least once per week to refresh the water in the shower head.
This all came to light when I wanted to do a good job of cleaning mould and calcium off the shower head. I felt the best job would be done by dismantling it and cleaning all the parts individually since some mould looked as if it had penetrated inside.