It can be very expensive to pay someone for removing a bra wire from a washing machine.
What Usually Happens
The wire normally gets caught under the heating element which is situated at the bottom, between the inner drum (the one you can see through the door with all the holes) and the outer drum which surrounds it and holds the water. The wire can lie dormant and not touch the inner drum, but if you know it’s in there then that’s worrying.
It can catch on the holes of the drum in such a way that it sticks through one, in which case you can probably grab it with your pliers and pull it out. If it pops through a hole while it is whizzing around it could do serious damage to the parts it is caught on, between the drums, or it could puncture the hose connecting the outer drum to the pump.
Would You Believe There’s Street Photography In Kabul
I just watched a video which has impressed me as a technologist and photographer. It’s all about Street Photography in Kabul, i.e. taking very primitive instant photos in the street. If you are a technologist or photography see if you are impressed too. Watch the video of How to use an Afghan box camera (a “kamra-e-faoree”) below:
You will find more to read about the Afghan Box Camera here.
“Me, worry about my bath overflowing? Its got an overflow pipe.”
“Oh! Has it?”
Why you DO NEED to worry about your bath overflowing?
I know someone who has had a bad experience with a bath overflowing, but it wasn’t their bath overflowing. It was in a flat two floors above. Interestingly the flat in between on the floor immediately below the bath didn’t get wet. How can that happen?
Well lets start with the overflowing bath. The person, whose bath it was, admitted it had overflowed but not very much. I suspect this means that the water did actually run over the rim of the bath. That means it rose above the bath overflow outlet (assuming there was one.) On my bath, water would start to go down the overflow pipe when it is within 8cm of the top of the bath. The top of my bath is 8cm above the bottom of the overflow. So if it is full to the point where it will overflow the rim of the bath the head of water pushing out through the overflow will be 0.08m whereas the head of water from the water level in my header tank in the loft is 2m. Alternative forms of hot water provision can be at mains pressure which usually has a lot more than 2m head. My point is that the tap’s pipe diameter and overflow pipe diameter are similar but the input pressure is a lot higher than the output pressure. Consequently baths can fill faster than they can overflow. So eventually a system with no faults may eventually overflow the rim of the bath if the taps are turned full on. So DON’T LEAVE BATH TAPS RUNNING WHEN YOU LEAVE THE BATHROOM. You may be distracted and forget about them. Continue reading “Should You Worry About Your Bath Overflowing?”